pushbikes

You may have read that in DV brochures etc. or been told that the alarm is pre-installed.

Well all that seems to be pre-installed in my apartment are the cable pipes but no cables, in these pipes is a single wire to pull through the cables.

In the wardrobe of the main bedroom is a white plate on the side and behind this is a void with a pipe/ single wire and a mains supply. 

However beaware that the mains supply consists of three wires black,blue and green and is live as I discovered when I was looking for the pre-install cables when I put my hand in. I have since put a connecter block on the bare wires.

This could have been a child putting their hand in here and been fatal.

PS Natalie and Pepe from AEA were with me when I discovered this, I was showing them the pre-install is not quite what you would expect when I found the other live wires.

Hi Jeff,

How easy is it to remove the cover?
Would you advise that any own renting out their apartment  should take corrective action in the case any curious renter my be at risk?

Did you manage to get any kind of wiring diagram?  I'm think it would be useful to post it on the community site.

Also, does anyone have a AEA supplied wiring diagram for the satellite connection point?

Paul

The cover is glued on with acrylic so may be a good bond or poor. Mine was quite tight.

There is no wiring diagram as there is no pre install for an alarm except power. You could work out which breaker is used and tape it in the off possible - I assume one breaker is asigned to the alarm wiring. I will check on my next visit.

I had a TV/satellite socket diagram from Maria Luisa in pre sales RyF.  Its in my apartment I will photograph on my return.

Basically you have to remove a filter to allow sky thru to your Digibox, you need a soldering iron and some small screwdrivers.